These brass fittings are used on my new X Craft and I need to get some more. The ring screws onto the end of the push-rod and the bolt goes through the ring and control arm. The nut secures the bolt.
As these are on a British built model, I suspect they are BA (British Association) threads. Not that it matters too much.
Does anyone have any ideas where I could get something similar?
OD of ring is .15" Overall length is .425" OD of shaft is .075"
As these are on a British built model, I suspect they are BA (British Association) threads. Not that it matters too much.
Does anyone have any ideas where I could get something similar?
OD of ring is .15" Overall length is .425" OD of shaft is .075"
Yesterday at 4:46 pm by tsenecal
» RC Drift Gyro for pitch control
Sun Oct 20, 2024 2:04 pm by geofrancis
» WW2 mini sub build
Thu Oct 17, 2024 2:34 pm by geofrancis
» sonar data link
Mon Oct 14, 2024 4:31 pm by geofrancis
» Robbe Seawolf V2
Sat Oct 12, 2024 3:52 pm by geofrancis
» ExpressLRS - 868/915 Mhz equipment
Fri Oct 11, 2024 8:58 pm by Marylandradiosailor
» Flight controllers as sub levelers
Fri Oct 11, 2024 8:14 pm by geofrancis
» 868/915 Mhz as a viable frequency for submarines.
Thu Oct 10, 2024 3:21 am by tsenecal
» Microgyro pitch controller corrosion
Wed Oct 02, 2024 11:32 am by geofrancis